Meziere Key Alert.

http://i1368.photobucket.com/albums/...psrwllo0wx.jpg

That was a stretch but I got the reference. Another one....

Gunna be honest, no idea how "Meziere" is actually pronounced. So i took the chance.

Beard? Check.
Body type? Check.
Goofy laugh? Check.

seems legit.

Braided line arrived today :nod:

http://i1368.photobucket.com/albums/...psyt3k9tep.jpg

http://i1368.photobucket.com/albums/...pscpov4p3i.jpg

http://i1368.photobucket.com/albums/...psejppwlcl.jpg

Fancy AN tools arrive as well?

No need, lines already assembled:nick:

So you just gonna raw dog them when tightening? Got it. Blue tape on an adjustable wrench will be your best bet.

Oh I thought were talking about line assembly.

How bout some felt tape instead ? That'll do the trick ?

Sounds fancy. Make sure to wear your velvet trousers when you do it.

Blue painters tape works fine if your careful. I was able to do a few fittings with minimal damage to anodizing

using protection AND wearing pants? your asking for a lot bls.

Mistakes happen without protection. :nick:

Life is all about choosing the right Emoji to cap your responses with.

That is some sexy lines Mr Beggarz

All wiring for convertering M6 dash harness to A4 dash harness is done. I think:bertstare: for the most part. Need to connect the ran wires to the shifter plug, but i gotta mount the shifter itself. Which hopefully today that gets done.

Also if i can get one of my buddies to come by, ill be able to throw the clutch cyl block off plate on the firewall in. It bolts in with nuts and bolts, and i cant reach both sides to tighten it. :cry:

If that goes in, dash can go back in !8-)

Take the steering column out :wink:

It is out lol but i cant tighten the bolts from inside the car, and hold the nuts on the fire wall at the same time. Need another set of hands

You're not trying hard enough. :rofl: That's exactly what I did in my 3rd gen, all by myself :nod:

just weld those nuts to the firewall

Carriage bolts from firewall engine side in.

#hellaflush

#custom #built #builtnotbought

Both block off plates are in.(Clutch Cyl and lonesome extra bolt hole for HVAC)

Shifter will have to wait till tmmr