NHRA Rule question
I am installing 5 pt harnesses into a Chevelle right now, and I need to install mounting tabs for the lap belt. Two questions:
1.) Can you bolt tabs to the frame, and then the belts to the tabs? Or do the mounting tabs have to be welded to the frame? 2.) The sides of the lap belts that mount near the trans tunnel can't bolt to the frame (since it doesn't run there). Can I use 1/8" 6x6 plate to mount them into (like you would with a roll bar)? |
I have the rule book in front of me. It does not specifically say in the general regulations (10:5 driver restraint systems) that you cant bolt tabs to the floor and then to the tab, but I did find under 10:11 (seat belts) that if you use steel plates they must be a min of 1/4" thickness.
|
Quote:
|
guys on tech said you can bolt eye bolts right to the floor and mount the belts to them..dunno how right that is though
|
Quote:
|
Quote:
Thanks guys! |
To be safe, buy the tabs from Jegs and weld them the the cage/floor.
|
All times are GMT -5. The time now is 07:27 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.