TBI OWNS! well sorta
 

went to the track again today (GM at Lebanon Valley)
had my best run so far. ran a 15.232 @ 89.35mph on a 2.188 60'. so derek u wanna run be4 u get ur new setup? :lol: the only thing i had done since i went 2 weeks ago was a set of UMI rear lower control arms. slowest i ran today was a 15.4ish compared to a fastest of 15.5 from two weeks ago. any got a set of drag radials i can borrow so i cna hit 14s?

congrats. tahts 2 tbi engines dropping new best times today. in the summer heat that everyone bitches about. :)

later
tim

TBI... pffffft, thats a thing of the past :-D :-D :j/k:

worst part there was a SS(LS1) and a z28(LT1) the ss could only hit a 14.001 he had chip intake, slp exhuast. LT1 had cold air, exhuast and was embarassed by me(guy ran a 16.3?!?!?! :shock: )

Re: TBI OWNS! well sorta
 

well im taking my car over to my buddy (hes a mechanic) because i ran my car before and i have ruled out anything wrong with the bottom end(or so i think)...anyway i think i might have a collapsed lifter or something to that sort associated with the valvetrain... so well see what he says tomorrow... the only thing keeping me from woopin your ass is my engine and a set of gears

::sets stage for Oct 16th @ Island::

TBI represent!





I hate tbi

pssst...post your new times in the timeslip list...sticky in the lounge

so guys its official... my motor is done and i officially dont know **** about engine sounds like rod knock... i took it to my buddy today and he said my rods are knocking and that i dont have very long for this motor... so it looks like the new combo's goin in very soon... he said i can see some extra life out of the engine with 20-50 oil and ill be doin that tonight so i can at least drive the car around until im ready for the swap... so planning for the new engine continues.... :|

I beat the everloving crap out of my old 2.8 for almost 6 months with rod knock.... :D

Sucks to hear man, some nice thick oil and gentle driving should help it last longer....

- Justin

Rod knock is the rod bearing going bad or missing :? . To be certain you have rod knock, look at the engine oil on the dip stick. Is there metal flake in it that makes it sparkle in the light? If so, yup, you've got bearings going bad, if not, it's not rod knock.