pulling a 350tpi/700r4...fun fun
 

as it sits now....at about 8pm tuesday evening....
http://i32.photobucket.com/albums/d5.../l98before.jpg
http://i32.photobucket.com/albums/d5...l98before2.jpg

I'm going to pull the motor now and not go to bed till its out and im satisfied with my progress tonight, lol. I'll post pics later tonight when im done :-)

u pulling it in one piece? its actually much easier to do that way,dont even have to disconect the ds or the tq arm they will slide out,just have to remove the plug/speedo cable from the trans,and the ex system mount .only works if u have an cherry picker that will lift high enough though

ok, its all out, and yes i pulled it as one piece, thats the only way i like doing it. I had the front of the car on jackstands and i still can lift the motor at least a foot higher than the rad support while set at 1 ton, so i think my hoist goes high enough. lol. And keep in mind i'm pulled apart 20-30 f bodies by now, so its down to a science. i'll have pics up later, camera battery is charging. I also pulled the front clip off since that'll be going on my 88 iroc as well, and it was easier to get the cherrypicker right up closer without the bumper.

http://i32.photobucket.com/albums/d5...SS/engine1.jpg
http://i32.photobucket.com/albums/d5...SS/engine2.jpg

emm thirdgens with **** in the usually places gotta love it lol never know what goodies ull find in the ancient leaves.

there was a squriles nest near the master cylinder in the corner when i got my 92 RS

LOL

what are you going to do with the engine and trans

:stupid:

its all going in my 88 iroc vert.

good luck with it