anyone thats good at welding interested in welding this?
 

this is a weld in "third mount" from autoweldchassis, i need it to be welded to my 9" rear sometime in the near future (within 1-2 months)
http://i28.photobucket.com/albums/c2...arm_mount1.jpg
(ill get a bigger pic of this tomorrow!)

itll be welded to this-
http://i28.photobucket.com/albums/c2...iver/REAR1.jpg
http://i28.photobucket.com/albums/c2...er/9incher.jpg

is it possible? my welding skills are limited and im def not up to this task

if anyone is interested, let me know how much it might be to do that.
i still need to buy an upgraded trq arm and hardware for it too

I dont understand what that thing is or where on the rear housing/third member it would get welded.

*edit*

I see the ford product is leaking already :lol:

that bracket is meant to replace the portion of the torque arm that is atached to the rear.
you may be better sevred to see what strange or currie use for torque arm bracekts and see if you can fab something off one of them.

I'm acutally a pretty decent welder (if I do say so myself) but unfortutely I have jack **** for time these days.

But let me ask you this- are you welding steel to steel or are you welding steel to cast iron? If the answer is the latter, you need to have a pro do it. Welding steel to cast iron requires special techniques and this is a critical part. You CAN weld steel to CI if you preheat the iron properly and use the correct welding equipment, but personally I wouldn't chance it on a torque arm. Something like axle tubes, no problem.

thats a very good point. cast iron is not the easiest thing to weld and if welded incorroectly will probably break.

hmmm, maybe ill call currie then. my buddy has a 9inch with a torque arm mount on there i think it like wraps around and bolts up or something.