Finally got around to my intake manifold pics.
 

ok well about 6 months ago I got done cutting and gutting my intake manifold off a GTP. heres a few pics and hopefully if i can find someone who knows how to weld aluminum I can get this thing put together. what do you all think, yay or nay if itll work cause if not, then whatever, no sweat off my bones, all I did was use a jigsaw, cut it open and use a carbide bit to smooth it over and clean a few burs inside. hopefully if it works it could be polished and ported as well later. it still needs a little more of a cleanup, but its looking good. ok here they are, and please dont flame me. Personally I think I took too much off, so Ill just get another one and leave more on there.





http://i176.photobucket.com/albums/w.../intake003.jpg

http://i176.photobucket.com/albums/w.../intake002.jpg

http://i176.photobucket.com/albums/w.../intake001.jpg