WTB 350
 

Anyone have a 1985 or earlier 350 for sale? Looking for a cheap one to build up for myself, let me know what you got

PM Wayne (rscamaro73) he's got one he is selling.

Yes, I have one from a 74 S-3 laguna (chevelle)....2 bolt, been rebuilt once i believe (can't be 100% sure since I never disassembled anything other than the intake and pan).

Got one guy ahead of you that's asking about it....but if he passes, you're more than welcome to it and the stand....below is the original posting of it....

http://www.nastyz28.com/forum/showth...30#post1024430

ive got one, 84 block, was still running when i pulled it out 6 months ago. Its an acdelco reman-ed 2 bolt, with about 9k miles. I you want to get it out of my garage i would be happy to accommodate you. Its got an edelbrock performer airgap manifold, accell plugs and aluminum valve covers. ive even got matching breathers, plug looms and wires if you want it all. the whole bag for $300? obo, picked-up of course, i have a hoist
________
Yamaha yzf-r125

what are you guys lookin to get for your 350s?

I have a old 2 bolt main block, also have a set of rods, and two cranks and one flexplate all for sale.

ok thanks, ill let u guys know, my buddy said he might have one and hes a trustworthy guy thanks for all the offers!

EDIT! My buddy screwed me over <3 that 350 is gone :( So i'll pm anyone with a good offer, thank you!

Still got mine.....here's the stuff off my site....

Link for my ad - http://www.nastyz28.com/forum/showth...&highlight=350

74 era 350 from a Laguna (Chevelle).....has been rebuilt in the past....rods are #'ered....can see some crosshatch from underneath. Was a clean, smooth running engine before being pulled. Not taken apart.....painted Chebby Orange....will include stand.....has been inside almost entire time (spent a month under the hood of a project I got rid of only).

Needs to go ASAP - paypal preferred....or CA$H upon pick up (hoist on site).

pick up only.....$300......

pix available....PM me or email me. wayne jorgensen AT gmail DOT com

Anyone is more than welcome to come take a look at it....I'm about 20-30 min from Scott (Bonzo) in PA (right near the Rt 1 tollbooths at the border)

good, stock, complete or long/short block, 350's go for $200-500 if they are all stock and in running/easy rebuildable condition depending what castings the block and crank are.

bare blocks can usually be found in the $50-200 range depnding what casting they are.

I want $80 for my bare block and one of my cranks, $30 for the other crank, $60 for the rods.