![]() |
Let me try this again. Just point me towards an amp.
Head unit: JVC KD-G230
Subs: 2 Alpine SWE-1041 Speakers: Stock for now Car: benz. What amp should I get? Not lookign for any show-winning performance, just something that'll power these subs I have sitting here fine :lol: |
an amp thats rms rating is 500watts and is stable at 1ohm, assuming your wiring it in parallel
|
No less than 500 rms and ur best bet is to go with a rocksford amp
|
dont go with rockford. rockford sucksssssssssssssssss. stick with alpine or jl.
http://www.crutchfield.com/p_500MRPM...cid=1586526400 i say go with that amp. and run both subs into the same speaker slots or get a 2 channel amp and bridge it. but this is the same thing. im running a 2 channel alpine amp bridged to my 1 10 inch sub and it hits hard. i also tried a 1 channel amp with 2 subs and hit just as hard and then you dont have to synchronize the subs or anything. |
kenwood 1000w... 120 bucks
|
his subs r only 200 rms...
|
Quote:
|
Erhm.. Alpine is just as bad as Rockford amps FYI. There both middle of the road. You want a mono amp, class D amplifier.. don't bother with 2 channels and all of that, that's not what their made for. IMO i would go with this http://www.sonicelectronix.com/item_...mpaign=froogle
Memphis makes solid amps and that will bench at a true 500watts. Wait... are these woofers DVC or SVC? SVC.. if you wire them in parallel you will have a 2 ohm load.. If they are DVC then, if wired in parallel, they will be wired down to a 1ohm load. |
Kenwood or Alpine... all I used for 6+ years.... also a member of SEMA
Worked in aftermarket since 2003..... |
Meh i wouldn't trust a Kenwood.. plus kenwood and Alpine are probably somewhat overrated. You should go with a Kicker amp. they always have made solid amp that are underrated.
|
soundstream it up
|
buy my f'ing amp
|
i dont do kenwood either. i do jl or alpine.
|
Quote:
|
damn am i the only one running pioneer? i have a full pioneer setup in my formula and it sounds great
|
Quote:
|
Quote:
|
Currently I have a 6.5 inch flipout pioneer dvd headunit, 4 gauge wiring through out the car with dist blocks and a 100 amp breaker, 2 pioneer front speakers, some cheap ebay rear sepakers hooked up to the headunit, 2 pioneer 10"s hooked up to a 4 channel pioneer amp(400 watts max i believe) bridged. My system sounds CLEAN and POUNDS. I have to admit my 200 watt 2 channel mtx amp iv had for 6 years actually makes my 2 10's hit harder than the 400 watt pioneer but w.e
|
Quote:
|
This thread is 9 months old, and the OP is trying to sell the car he was looking for an amp for. No need to keep going with it....
- Justin |
All times are GMT -5. The time now is 11:31 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.