nothing like carbon and fuel in the morning
 

Click here to watch LT-headers
finally go the camera to work for 5 mins so I could do this video... LT headers for a 2nd gen and a leaky Y pipe, I can't wait to get my 3in cat back I might even do dual glass packs.

Those of you who were at atco will notice the back fire is gone

its so funny how the pixels get messed up when you revved it. Its like something that was editied but, in this case its just the focus on the camera. Sounds good man

thanks
yea the camera was vibrating....:rofl:

i tried to make a exhaust vid, i knocked my camera over...:mrgreen:

i posted this before on TGO, but how did you get 2nd gen headers on that? got picks from underneath and side?
________
No2 Vaporizer

well a hot torch and a really big hammer, was good to have, I had to pull the dizzy and lift the motor about 9in. then I had to make some kind of wacky ass Y pipe because the headers were only 8in from the cross member so I need to have a custom Y and cross member made and I need to make more "clearance" (AKA hammertime) I'll post up pics when I do the started sometime today.... they ave VERY tight but they are much longer than 3rd gen LTs so I'd imaging that would help in the torque area.