FS 3.42 gears for 10 bolt
 

I got done with my differential swap on my car today and ended up going with 373's. I was expecting the stock ring and pinion to be wasted but they ended up being in PERFECT condition. gears have 61k on them, no chips, dings etc. I've also included part numbers so you can look it up to ensure they are in fact, stock 3.42's that came out of a manual car.

Also will include what i didn't use of a motive install kit. What is included is all pinion bearings with races plus pinion seal, 1 carrier bearing without race, unopened pack of pinion shims, unopened pack of carrier shims, red thread locker, gear paint and brush(only used a little to make sure the pattern was good), 1 rear cover gasket. What I used from the kit is crush collar, pinion nut, ring bolts, and race from the carrier bearing.

$75 for everything

http://img.photobucket.com/albums/v2...Picture797.jpg

http://img.photobucket.com/albums/v2...Picture798.jpg

http://img.photobucket.com/albums/v2...Picture800.jpg

http://img.photobucket.com/albums/v2...Picture801.jpg

http://img.photobucket.com/albums/v2...Picture802.jpg

do these whine at all?

I had ZERO whine with these gears.

bump