NJFBOA - Home of New Jersey's Camaros and Firebirds

NJFBOA - Home of New Jersey's Camaros and Firebirds (http://www.njfboa.org/forums/index.php)
-   Engine / Power / Tuning (http://www.njfboa.org/forums/forumdisplay.php?f=31)
-   -   Removing Torque management (http://www.njfboa.org/forums/showthread.php?t=47336)

FASTEDDIE Z 10-09-2009 04:52 PM

Removing Torque management
 
Can I or anybody on this board remove my torque management or do I have to get it "tuned " to remove it ? Will a hypertech p3 remove it ? I just want to get all I can out of it until I do the converter , LS6 intake and headers . THEN get a full tune . I only have minnor bolt ons right now . Magnaflow c/b , K&N and a SLP lid .

Whiplash Performance 10-09-2009 06:32 PM

Quote:

Originally Posted by Eddie D. (Post 643215)
Can I or anybody on this board remove my torque management or do I have to get it "tuned " to remove it ? Will a hypertech p3 remove it ? I just want to get all I can out of it until I do the converter , LS6 intake and headers . THEN get a full tune . I only have minnor bolt ons right now . Magnaflow c/b , K&N and a SLP lid .

Most programmers will reduce the effect of torque management and not completely eliminate it. A regular tune by a good tuner is a lot better then any programmer. We could help you out with either way you want to go.

Jersey Mike 10-11-2009 12:53 AM

I got a dyno tune & my tuner eliminated my Torque Management system, per request.
The following week, the 10 bolt died.

Featherburner 10-11-2009 08:50 AM

Quote:

Originally Posted by Jersey Mike (Post 643602)
I got a dyno tune & my tuner eliminated my Torque Management system, per request.
The following week, the 10 bolt died.

Probably no correlation between the 2. I mean it's a 10 bolt. LOL


All times are GMT -5. The time now is 12:56 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.