![]() |
slp cold air kit
Just installed slp cold air kit on my lt1. It started running perfectly, after about a half hour it started stuttering a little bit and losing power. Has anybody had to clean their MAF sensor after the install. I vaguely remember reading that somewhere.....Any suggestions??
|
How do the wires to your IAT look?
|
I would unplug the maf and see if it runs better. You should also check all of your intake and plug connections for proper seating/sealing
|
The IAT sensor wires should be fine because I didnt take off the rubber elbow. I'll check everything though tomorrow. I did slightly dent up the screen of the MAF but hardly. Thanks for the suggestions, guys
|
Quote:
|
I cleaned the MAF with MAF cleaner the next day and its been fine since. Thanks
|
All times are GMT -5. The time now is 02:34 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.