NJFBOA - Home of New Jersey's Camaros and Firebirds

NJFBOA - Home of New Jersey's Camaros and Firebirds (http://www.njfboa.org/forums/index.php)

- Restorations, Fabrication, Tool and Shop Tech (http://www.njfboa.org/forums/forumdisplay.php?f=53)

- - Best Spot Weld Cutter? (http://www.njfboa.org/forums/showthread.php?t=56965)

iroc86NJ

08-13-2011 06:28 PM

Best Spot Weld Cutter?

As the description says. What is the best spot weld cutter available?

I'm replacing the driver side floor pan in my third gen and have got a ton of welds to drill out, so I need a quality tool to tackle the job.

WildBillyT

08-13-2011 06:31 PM

http://www.njfboa.org/forums/showthr...ot+weld+cutter

Rich2279

08-13-2011 08:50 PM

I used one by the company Blair. It is double ended. You have to be careful with it, though. I remember the blades kept snapping off.

transmaro93

08-14-2011 10:46 AM

any of the ones that the blair company offers are good. just drill your 1/8 pilot holes and your good to go.. and use cutting oil when drilling cause it will greatly extend the life of your bits...

iroc86NJ

08-14-2011 12:21 PM

Quote:

Originally Posted by Rich2279 (Post 780437)

I used one by the company Blair. It is double ended. You have to be careful with it, though. I remember the blades kept snapping off.

Thanks for the info. Seems like i have to decide between the Blair anti skip or the Blue Point.

All times are GMT -5. The time now is 09:15 PM.