NJFBOA - Home of New Jersey's Camaros and Firebirds

NJFBOA - Home of New Jersey's Camaros and Firebirds (http://www.njfboa.org/forums/index.php)

- Wanted To Buy - Automotive (http://www.njfboa.org/forums/forumdisplay.php?f=59)

- - Carb Spacer Plate (http://www.njfboa.org/forums/showthread.php?t=62069)

LTb1ow

12-08-2012 12:47 PM

Carb Spacer Plate

Looking for ~ 1/2 inch one, lemme know if you have one

Vic E Intake

WildBillyT

12-08-2012 03:06 PM

4150 flange. Right?

S.J.SLEEPER

12-09-2012 03:08 PM

make one? I think I have some 1/2" aluminum t6 sheet

LTb1ow

12-09-2012 06:18 PM

Quote:

Originally Posted by WildBillyT (Post 862180)

4150 flange. Right?

I have no idea :rofl: Its a square thingy thats not a stock LT1 intake.

Quote:

Originally Posted by S.J.SLEEPER (Post 862286)

make one? I think I have some 1/2" aluminum t6 sheet

I may, making a plug for the opti at work, may just make one on the mill.

wretched73

12-10-2012 09:53 PM

4 hole? single hole? What type of material? There is a whole lot of info about benefits of material types.

V	12-10-2012 10:03 PM

Quote:

Originally Posted by wretched73 (Post 862532)

4 hole? single hole? What type of material? There is a whole lot of info about benefits of material types.

I'm gonna guess he's looking for a larger single opening plate. And not too picky about material.

I may have one, I'll look around tomorrow.

LTb1ow

12-11-2012 04:46 PM

Yea large opening, and material doesn't matter, EFI.

V	12-11-2012 10:04 PM

I tried looking today but a near avalanche prevented me from proceeding further into my quest. It will take me a few days to excavate properly and search the location I last remember it being in.

Featherburner

12-12-2012 02:37 PM

Just go old school and use a piece of plywood!

LTb1ow

12-12-2012 04:50 PM

Wood is cheesy and its a pain to mill. Was thinking about a piece of garolite..GME/GMG etc. But, still cheesy and in the end, cost more to make than for me to buy one :lol:

All times are GMT -5. The time now is 11:12 PM.