Need an AXLE BUMP STOP for my 1994 Trans Am
 

I was just checking my new toy out, pulled the L.S. rear wheel off and saw this. What really floored me was the price ($70.00 apiece from GM):shock:. I got a price from NAPA for $48.00 each. Anybody had to replace these and what did they run you? Thanks for any help.

Are you looking for a direct OEM part matching kinda thing?

Umi sells them for like 70 for both, can always cut the lip off the body and run jeep cherokee ones that are 20 bucks or so

:nod:

https://www.summitracing.com/parts/ens-9-9137g

take a angle grinder with a cutoff wheel and trim the lip. spray paint the exposed edge. The price has gone up. I paid 17.95 back in 2013 for those.

I cant see it well. Whats wrong, the undercoating is peeling off?

4th gen bumpstops are worse then thirdgens. They are more of a foam then rubber. His are actually not as bad as I seen cause its actually still there. Most crumble and fall the f off.

i see. Hmm

mine were MIA so I did the ones deadtrend linked. super easy install

No, It's DRY ROT. Your can dig chunks out of the cracks.

Yes that's the problem. The ones on my 1991 Formula looked brand new and were made out of solid rubber. These are made out of a orange foam. The rubber ones will fit 1982-2002. Thanks for the info!

im actually looking into the polyurethane ones from strano for my 99 ws6. they apparently dont make them anymore so you need to buy aftermarket.

and wait a second...you have a 94 trans am?

Yeah, just brought home a 25th Anniversary Trans Am GT. It's a 6-speed manual (only 128 made) 19,000 miles and Mint Condition. I got a set from Eric (732-616-8794) who has 2 garages filled with 3rdGen parts. Give him a call (he's in Jackson, NJ) and mention my name and see what he charges you for them. They will be the Hard RUBBER design and fit perfectly.

the jeep ones are out of stock? just use those.

Or just remove em completely.

:shrug: mine just fell off

You don't need them



Until you do.

Mine have been MIA for years now. Lol

This lol

Give Eric a call. He is on thirdgen.org and has several sets of the HARD RUBBER design. I bought a set from him (he lives in Jackson, NJ) and they are a perfect fit. His number is 732-616-8794. He has 2 garages filled with 3rd Gen stuff and his prices are really fair.:nod:

What did you do with the 91 Formula?

The Insurance gave me FULL Value for the Formula and the BUY BACK was $4,000:shock:, so now it went to the auction block. Sad ending for the Bird that I had for over 24 years, but the amount of work finding parts and then getting a SALVAGE title was too far out. I did buy a MINT 1994 25th Anniversary Trans Am 6-speed/ 18,000 miles.:nod:

http://umiperformance.com/catalog/in...oducts_id=1006
I lied, there 30 bucks, might have been the hawk ones i was thinking of

I'd get those. I like rubber stops over poly. more progressive

I ran mine to far worse of a condition than those and then did the poly Jeep set since nothing rubber was available. I just picked up a set of the UMI ones this week.

I'am quite sure Eric would have sold you a used RUBBER set for a lot less than the POLY replacements. The rubber will have some give, but unless you doing road courses they will work just fine. Plus if it matters, when you clean them up a little, they look brand new.