Hey New member
 

Hey guys new to the board heard alot of good things this forum. I currently drive a 84 Camaro z28 with

350 .30 over .480 lift comp cam,edelbrock headers,edelbrock 670 Street Avenger carb,edelbrock performer rpm intake,heads ported decked 3 angle valve job, 700r4 tranny 3.73 gears,powertrax locker
lakewood lower control arms and lifter bars,panhard bar,polygraphite bushings.. As some of u already know (jOn) the name says it all iCANTtune haha

Later guys

good to see you finally made it over here...if you're up for a trip you should think about the next monthly meeting this saturday at fudruckers on Rt 22 in bridgewater...and yes he really cannot tune :lol:

welcome to the club. hope you like it here :)

later
tim

hey man welcome

welcome :cheers:

Welcome, hope you like it here. :)

Welcome to the club!

Which cam do you have in your car?

- Justin

Welcome:lol::D

I was only told it was a .480 comp cam i didnt get the car from the guy who built it. If i remember right though i could only find .230/.480 comp cams (hard to remember numbers :roll:) so i assume thats what it is but i could be wrong.

Welcome from another newbie!

welcome to all new people :wavey:

Looks like the only SBC Comp Cam with a .480/.480 lift is the Magnum 280H It's a 230/230 @ .050 with a 110 LSA. That's a pretty good sized cam.

You should try to track down the guy who built the motor for more specs on it.

Sounds like a pretty strong running car!

- Justin

it would be if his user name wasnt what it is lol

Welcome. I usually don't welcome people but this quick reply is pretty slick stuff!