way to bring back a thread from sept... lol
Injuneer...the BMR brackets i have should be fine for me. Since when i do a 9" it'll be an aftermarket housing with all the brackets cut from a stock 10 bolt and tig welded to the 9". so everything should fit, even if it involes some cutting and welding.
Transam4life.... the TQ arm, lcas, and panhard rod are all exactly like a 3rd gen, all the same style, most parts even swap over the same. Â*the TQ arm i have is for 93-02 only because it mounts now to the body and not the tranny anymore. But if you worked on a 3rd gen, this will be just like it.
wasted....what style panhard is it? Â*im mainly looking for an adjustable one with spherical rod ends on both sides and single adjuster in the middle. Â*Also is it a brand name or a custom one.
and i have yet to install my relocation brackets, haha, i have been busy with work all fall so finally this winter ill get to it. Â*I'm doing a lotta work on the rear suspension and body. I have to install my replacement driveshaft(bent mine), subframe connectors, New LCAs, panhard rod, install relocation brackets, new rear lowering springs, poly sway bar bushings. I just gotta sell some of those gta parts soon to be able to buy the new parts. then i'm also taking my euro bumper back off and sending it for paint and wiring up my rear fogs.
thatll hold me over a while till the engine swap, then i'll install a tubular k member and tubular front control arms, and then the roll cage goes in.
