[EVIL90SS]

well, after the cam swap...it ran ok, well it started to tap again...soooo...i took off the valve cover and one of my new rockers was turned sideways and the pushrod was bent ...tried pullin it out and snapped in half so i had to take off the intake.....pulling out the lifter to check that too, and it looked odd....yea..it had about a 1/4 inch of metal shaved off of it, and yea...the cam lobe was also rounded off and f-ed up....grrr....say goodbye to my new cam....ohh theres more, so i took the head off to check if it may have bent a valve, nope...but i figured hey..why not change both gaskets...well, the driver side oil passage in the head is broken out twice its size....where did that steel chunk go...hmm i dunno, but i get to lookin at the rear piston and hmm...why atre there a few chunks missing and a few 1/8 in holes in it ? WTF !, and on the head on that same cylinder and equal amount of gouges !!! well thats it for now...i dont know what the hell im gana do but i gata do somethin...the motor has 86k on it.