NJFBOA - Home of New Jersey's Camaros and Firebirds - View Single Post

V · 01-25-2006, 05:51 PM

lemme look... hold on...
Untamed.. are you goign to the trucks gathering tonight?

dahm, no luck in my parts boxes(nuts bolts clips etc)
i may have put them in the center console of the monet which my GF drives. i'll check there tonight.
However, if you read this before the trucks meet and your going, let me know, and describe it as good as possible, ill rip one from one of the 10 or so 3rd gen doors i have in my backyard and bring it down tonight.

Steve, are you talking about the metal clip that pushes through and sorta tas a tab on one side a little lower that hols the clip in place? if that it i found those, but the clip im thinking of is like a plastic/nylon clip that goes in the hole with the rod and then "swings" around to hold the bar.

01-25-2006, 05:51 PM	#7
V Stalker Join Date: Aug 2004 Posts: 12,082 iTrader: (12)	lemme look... hold on... Untamed.. are you goign to the trucks gathering tonight? dahm, no luck in my parts boxes(nuts bolts clips etc) i may have put them in the center console of the monet which my GF drives. i'll check there tonight. However, if you read this before the trucks meet and your going, let me know, and describe it as good as possible, ill rip one from one of the 10 or so 3rd gen doors i have in my backyard and bring it down tonight. Steve, are you talking about the metal clip that pushes through and sorta tas a tab on one side a little lower that hols the clip in place? if that it i found those, but the clip im thinking of is like a plastic/nylon clip that goes in the hole with the rod and then "swings" around to hold the bar. Last edited by V; 01-25-2006 at 06:12 PM.