My plans so far...opinions/advice?
6.0L LQ4 iron block, (4.030" bore) (Painted silver
)
-Lunati rotating assembly:
4.125" stroke crank, 6.125" rods, -38?cc dish pistons(whatever
dish will yeild 8.5:1 C.R.)
-Dart LS1 heads, 62cc combustion chamber,225cc intake runners,
2.05"/1.60" valves, 1.290" single springs.
-YellaTerra 1.7 ratio rocker arms
-Comp cams pushrods
-Comp cams lifters
-Crane double roller timign set
-BBK 80mm throttle body(or similar)
-OEM LS6 intake manifold
-Aeromotive billet fuel rails 5/8" ID
-Ported LS6 oil pump
-MSD coils
-MSD plug wires
-ATI 1-DSC blower setup w/twin aftercoolers
-TCI balancer
-Pace setter LT headers
-x-pipe w/true dual exhaust
-Tuning by Bill
(SD tune)
-2 bar MAP sensor
-OEM valve covers, oil pan, and engine covers
camshaft? blower application?
injectors? 50+lb?
Did I miss anything? I may have, its getting late. Build date will be between June '06 and Jan '07.
Some further vehicle mods will be a roll cage, ford 9" rear, carbon fiber driveshaft, Spec stage 4 clutch, and tubular front suspension w/QA1., etc.