Thread: BADDD rotors...
View Single Post
Old 04-20-2006, 06:28 PM   #8
BonzoHansen
Admin.
 
BonzoHansen's Avatar
 
Join Date: Aug 2005
Location: Hamilton, NJ
Posts: 20,165
iTrader: (27)
Sometimes new rotors are bad. Especially a lot of no-name (ie cheap) aftermarket. My best tech used to run a slow final cut on the lathe for any no-name rotor he installed. He hated comebacks (one of the reasons he was my best tech). I'd say 1 in 20 were not quite right.
__________________
Vent Windows Forever!

The looser the waistband, the deeper the quicksand. Or so I have read.

Feather-light suspension, Konis just couldn't hold. I'm so glad I took a look inside your showroom doors.

Hey everybody, it's good to have you on the Baba-too-da-ba-too-ba-ba-buh-doo-ga-ga-bop-a-dop

Last edited by BonzoHansen; 04-20-2006 at 09:22 PM.
BonzoHansen is offline   Reply With Quote