View Single Post
Old 06-12-2006, 10:03 PM   #16
Untamed
 
Untamed's Avatar
 
Join Date: Aug 2004
Location: Hillsborough, NJ
Posts: 3,200
iTrader: (1)
Yeah just replace the parts of the harness that are burned out, or replace the entire harness if you're unsure what else was damaged.

Unfortunately there's nothing easy about replacing wire harnesses, especially if the parts you need to replace run through the firewall. Also check all the sensors to make sure they weren't damaged in the fire. If so DONT FORGET to put a drain pan below the block before you start yanking sensors. On a third gen, the temp sensor sending unit is (at least on late third gens) on the driver side above the axle, so not easy to get to. Check everything you can.

Thats rough you had the fire. At least you don't have to worry about getting a ride to work every day.
__________________
I USED TO HAVE an 85 Camaro 305 4bbl, 90 Firebird V6, 97 Firebird V6 (10 speakers!). Despite the two family vehicles, 3 kids, wife and mortgage, I can finally realize the dream - 88 TA almost all stock... for now.

http://www.cardomain.com/id/untameddave

Wanted this - , but ended up with this - for free. Can't argue with free.
Untamed is offline