NJFBOA - Home of New Jersey's Camaros and Firebirds - View Single Post

V · 06-21-2006, 07:50 PM

its a 84-92 T5 setup with hydraulic linkage(out of a 1988 Iroc Z) I need to change the clutch master, but i havent ever looked into how to bleed the system once its opened. I have brand new master ready and i ahve to pull the inner wheel well to change it so i wanna do it once and do it right, lol.

I was planning to swap it out anyway with the new one, lt1 braided clutch line and LT1 T56 slave cylinder when i swapped in the T56, but since it went now, i MAY install the T56 this week just so its all done at once. I;m just gonna need to find someone thats able to do some custom welding to modify my current T5 crossmember.

06-21-2006, 07:50 PM	#1
V Stalker Join Date: Aug 2004 Posts: 12,082 iTrader: (12)	How do you bleed hydraulic clutch? its a 84-92 T5 setup with hydraulic linkage(out of a 1988 Iroc Z) I need to change the clutch master, but i havent ever looked into how to bleed the system once its opened. I have brand new master ready and i ahve to pull the inner wheel well to change it so i wanna do it once and do it right, lol. I was planning to swap it out anyway with the new one, lt1 braided clutch line and LT1 T56 slave cylinder when i swapped in the T56, but since it went now, i MAY install the T56 this week just so its all done at once. I;m just gonna need to find someone thats able to do some custom welding to modify my current T5 crossmember.