|
ok i recieved the wiring harness, seems pretty straight forward from reading the installation booklet. I have a few questions regarding taking the old one out. the dash part, do i have the remove the dash pad and the tubing for the AC, instrument panel to wire this harness for the dash section. The booklet explains real well on which wires go where and which ones you have splice but it doesnt give any details about the actual procedure to get the wires there. The engine compartment seems pretty straight forward. The tail part is a little tricky too. For the fuel wire do i have to run the wire all the way to the fuel pump or can i get splice it into the wire? The VSS wire i guess you saying before splices into the tach wire am i right about that? The torque converter wire do i even use it lol?
Also the relay wires seem short. I know the MAF and burnoff are in the engine compartment but this wiring harness, has them right next to the ECM. Now I am sure that it is ok to hook up them and put them under the plastic trim that hides the ECM right?
man i have alot of questions LOL
|