well, its now finally all installed, wired, and working. I just finished up wiring it at the main box this morning(i held off till i got back from my sis's wedding in detroit) I had ran the wiring and did all the connections in the garage last week. After talking to an electrician and a general contractor, i went with 8/2 wiring from the box to a single surface mount recepticle in the garage and then a section of 8/2 to the compressor itself. When i install my lift, i'll just run 8/2 from that to the outlet and use another plug. Since the lift will be used rarely, i'll just unplug the compressor when i need it. After it was all wired, i turned it on and it ran great, filled the 60gal tank to 135psi in under 10 min. and after fixing a few leaks in the lines I am now set. Later today or tomorrow, i'll change the valve springs on my motor, lol. heres a pic of it setup, now i just gotta clean up/setup around it....
