View Single Post
Old 08-11-2006, 09:19 PM   #39
j0n
 
j0n's Avatar
 
Join Date: Aug 2004
Location: Somerset County
Posts: 5,559
iTrader: (5)
Quote:
Originally Posted by lethalrides2k3
dam got a decent amount done,anyways ill head over once im done with kasey's car at the shop tom,not sure what time,it all depends on when the fidget gets to the shop and how fast he works
yea did well until about 3pm(ended up starting around noon)...then i had lunch and slowed down quite a bit.

However, i did manage to muscle the old motor off the k-member and slap the new one on, bolt up the acc. bracket, all the misc. sensors blah blah blah so the whole assembly is all ready to get bolted up and in tomorrow

Pics from about 7:30-8:00:





and of course a HUGE thank you goes out to UBG for givin an extra hand when i needed it to wrestle that fuggin trans onto the new motor

FOR TOMORROW:

I may need an impact gun and i definately need an 18mm half-inch drive socket(my 18mm socket got jammed on my impact)

To do list:
-slide front subframe under car
-drop car on subframe
-bolt subframe in
-wire new motor
-install radiator and hook up all coolant lines
-make a run to the parts store for the pcv line that runs from the valve cover up to the throttle body
-drop rear
-drop fuel tank
-install walbro pump
-re-install fuel tank
-bolt in new rear
-go get my new driveshaft
-bolt up exhaust
-fluids and start tuning

:sigh: gunna be another long day
__________________
1999 Corvette FRC
j0n is offline   Reply With Quote