Quote:
Originally Posted by j0n
if the pcm sees not enough voltage from the sensor it reverts to some pre-established table that pulls specifically 4* of timing and will do it all the time until that voltage is restored...desensitizing it will only work if the wiring is all good
|
jon I know that...when i say desensitize in his case I mean turn it off...there are 3 or 4 tables that will pretty much turn them off through settings, but there is no on-off switch in the pcm for this so I call it desensitize in this case but yes its turning them off just as if you were to wire in a resistor.