I finally went to put on the new rotors/pads on my car today and i got as far as getting the wheels off.
I couldn't get the calipers off and it looks like some of the bolts have been stripped. [which may not even be the right bolts]
I got a bolt-out set from Sears but it was mismarked and the 1/2"-13mm doesn't fit a 13mm bolt. Now it would be too easy for sears to sell sets in relative incriments, so they'll sell you odds or evens or something like that. got one set, doesn't fit but i need the next size up, but it was too late so i have to go back another time.
Threw the wheels back on to try and get my new horn in but i have to cut and crimp wires through the tiny access panel so I threw the old one back on and i got absolutely nothing done today.
exactly which bolts do i take out on the wheel to get to the calipers? there were two that looked like they require a giant hex?
I think i'm done... for now