Ok, i have a Hurst Roll Control setup I'm installing in my car. Its brand new and i got it years back, and I have since lost the instructions.
I bought the pre-bent line kit from Thunder Racing to make it a little easier, but i still have some questions.
When i first installed the lines to the solenoid a few months back, im pretty sure I had the instructions so i believe the lines are in the correct positions, but i'm not 100% positive. I'd just like to double check that.
Also, the solenoid has 4 ports, one on top, 2 on side and 1 on bottom(when mounted)
Looking at this 2nd Pic, this is what i have...
A. Out to ABS unit as Front line input
B. plugged? id need a real plug(fitting is just there so i dont lose it.
C. Plugged
D. Input from Master Cylinder
... Also, i assume i should use teflon tape on the fitting ONLY on the solenoid, correct?
And where can I get the plug i'd need for the port B?
The other parts from the kit i have are the following in the last picture.
When wiring it up, im assuming I should just run the power for it from an accessory source, not batt.
