|
How to prevent Spun bearings...
Someone please tell me!
My motor combo is pretty simple yet some may consider kind of dumb since I am playing Russian Roulette on a stock bottom end but it was all I could afford at the time.
Engine:
-Comp Cams CC306 (230/244 .544/.576 112 lsa)
-Comp Magnum 1.52RR
-Comp .0072 Chromemoly Push-Rods
-Stock Lifters
-Comp 977 spring
-Comp Ti +.050 retainers/seats/locks
-ARP 7/16 studs
-561 casting heads flowed @ 255cfm @ .500 lift
*54cc Chambers
-ARP Head Bolts
-Racetronix 255lbhr Fuel Pump & Hot-Wire kit
-Lunati Double Roller Timing Chain
-Port Matched LT1 Intake with Ported Runners
-GMPP EGR Block-Off plates
-Enlarged Throttle Body Opening (sized for 58mm throttle body)
-Stock ported Throttle Body
-Meizer Electric Water Pump
-!AIR/EGR
-Throttle Body ByPass
What should I look for to build into a competent bottom end that can handle 350-450 crank horse?
__________________
Last edited by ar0ck; 05-09-2007 at 07:04 PM.
|