IF you have an LS-based motor(out of the car would be best/maybe noly way) and a set of Kooks or QTP
LT headers... i need some measurements.
Do me a favor, and put the headers on upside down(and exhaust coming forward) and see if theyll even clear, they should. Obviously they wont fit if the motor is still in a car for the most part.
I need to know how high they come up over the top of the BLOCK, like put a straight edge acroos the highest point of the headers and drop a line from the middle to get the height off the top of the block(not intake manifold)
I also need the measurement of how far in FRONT of the headers the collectors end.
The final measurement i need is the width apart the headers are at the top. there my be two of those measurements, one of the primaries towards the back of the block, and then how far the collectors are apart from each other(outer edge to outer edge)
pics wouldnt hurt either.

Thanks in advance