Ok, i have decided to finally get off my lazy *** and make some legitimate plans for the car...
This is what I was planning on engine wise:
-The heads and intake would be shipped out to Lloyd Elliot to get ported and polished. I am leaning towards his LE2 package.
link:
http://www.eportworks.com/lt1.html
-I am probably gonna have the stock block either rebuilt, or I am going to purchase a new one, probably a bored out one. I saw this one from Summit, but I am not sure if it will work or not:
http://store.summitracing.com/partdetail.asp?part=MLL%2DBP3831&autoview=sku (this is where i need the most input on)
-Of course, the basics will get done too, bigger injectors (30# or 36#, not sure yet), 58mm TB, 1.6 Roller Rockers and a good tune.
The other I have planned:
-Send trans to CPT to get Rebuilt.
-a lightweight K-Member, A-arms.
-Rebuild the 10-bolt with 3.73s, or 12-bolt with 4.10s
-Fresh coat of paint
-New seats
-Finish suspension
But all this isn't set in stone. I am open to, and hoping for, some opinions on what you guys think. Plus recommendations are always welcome. Thanks guys.