Ok so i'm NEARLY done with putting on my new rear and i ran into one tiny thing which is the only reason why im not on the road. Where the torque arm connects in the front, by the transmission, it goes into a rubber kinda holder thingy majiger. There are two bolts on the bottom and one on the top. The bastard at the top wont go in, i was at it for hours. AND NO ITS NOT SOME STUPID MISTAKE LIKE A STRIPPED BOLT!
If anyone has dealt with this any input would be much appreciated, or even if they wanted to stop by for a little
Thank you!
__________________
1983 camaro- Scrap
1988 camaro- Also scrap
'05 Silverado- You guessed it, scrap
1988 TRX 250R- Ported w/ high compression on 110 octane- Out 60' your LT1
Jersey Shore Street Car Takeover (JSSCT) Founder
Quote:
Originally Posted by LS1ow
and once i get PHB, what do i ajust it too?
|
Quote:
Originally Posted by Jersey Mike
Seven.
|