[Blacdout96]

You shouldnt of had to grind the rim at all, that weakens the bead and tire. To make things fit with the 315's is you have to bang in the inner fender. Make sure you have your back seat in place cause if not it will distort the rods it clicks into. Its not hard to hit it, hell I used the wooden end of my sledge and it bent right in. And dont forget to recoat it with undercoating after your done. Drive it for a few miles, take off your tires, and see where its rubbing, and keep banging it till your tires stop taking the undercoating off. Aslo you might have to bend your fender up top, I had a problem with ym car doing that, without anyone or anything in the back, so I rolled it up, and its never rubbed again. also if your having rubbing problems, you need an adjustable Panhard bar to center your rear.