|
Havent seen that much rust on any hub bearing, nothing that a BFH couldnt take care of. On your car, you dont have to worry about the CV axle, so a tap here, tap there, and plunk onto the ground.
PB Blaster couldnt hurt either...
Hub bearing will hum around 30-40mph, and get worse when turning. Make sure when you are checking it for up and down movement, that if you do notice movement, that its not the ball joints, or if you try side to side, thats its not the tie rods.
__________________
2/20/2013: They Day the ****s Stopped
Last edited by BigAls87Z28; 03-10-2009 at 12:58 AM.
|