View Single Post
Old 09-11-2009, 11:32 AM   #4
Scrat's_Camaro
 
Scrat's_Camaro's Avatar
 
Join Date: Oct 2008
Location: Clayton
Posts: 521
iTrader: (2)
yeah i replaced the lines cause i was smelling some fuel vapor and it was setting off the evap code and i noticed some charcoal dust in the valve so i decided to replace everything. the thing is im not getting enough vacuum to operate the valve though but if i hold my finger over that one hose then the valve opens. i know the purge line from the motor has enough vacuum going through the hose cause it will open the valve up if i hook it up directly but just not when its hooked to either old can or the new one. do i need that fresh air line or can i cap it off?
Scrat's_Camaro is offline   Reply With Quote