Thread: Install Help
View Single Post
Old 09-21-2009, 01:35 AM   #29
Czop418
 
Czop418's Avatar
 
Join Date: May 2009
Location: Detpford New Jersey
Posts: 204
iTrader: (0)
.... i wouldnt recomend the motor mounts . because you need to have the riviting tool , or be a damn good welder to make sure it stays. from what me and my friends expierienced bolting the mounts in instead of the using the rivits wont allow you to fit properly not to mention the flex / steady vibration actuallys cause the bolts holding the mounts in to loosen. but yeah if you need anyhelp with anything just give a post. like i said just disconect the steering knuckle 2 bolts and a good whack with a hammer. and take out your starter and you should be fine. and dont forget change those plugs/wires.
Czop418 is offline   Reply With Quote