Thread: Install Help
View Single Post
Old 09-21-2009, 07:32 PM   #31
LTb1ow
Mongo the Meet Coordinator
 
LTb1ow's Avatar
 
Join Date: May 2008
Posts: 16,938
iTrader: (8)
Quote:
Originally Posted by Czop418 View Post
.... i wouldnt recomend the motor mounts . because you need to have the riviting tool , or be a damn good welder to make sure it stays. from what me and my friends expierienced bolting the mounts in instead of the using the rivits wont allow you to fit properly not to mention the flex / steady vibration actuallys cause the bolts holding the mounts in to loosen. but yeah if you need anyhelp with anything just give a post. like i said just disconect the steering knuckle 2 bolts and a good whack with a hammer. and take out your starter and you should be fine. and dont forget change those plugs/wires.
I would chance them loosening than having to listen to my brand new headers smack the floor every time you nail it.
__________________
Quote:
Originally Posted by KirkEvil View Post
repo bigals turd gen and part it out to a loving home
LTb1ow is offline   Reply With Quote