OK so this is the hei - far less confusing than i once though but still questions
the plug from the bottom does fit into the cap - didn't notice there are two spots there. so It looks like all i have to do it have a line from the bat and a line from the tack.
now on the old points one i had two lines going to the coil on my firewall, is that my power and tack lines? obviously I need to 10g wire now for the hei but that would make locating the tack wire so much easier. Now do i just run a wire with a fusible link in it to the hei right off that battery (+)? there is a nice little connection built right into my new +power cable going from the bat to the starter. If not where should the power come from then.
also do u thing one of those two line that went to my coil is from the tack? couldn't I just hook that up? Excuse my ignorance if Im over simplifying this
