I've been busy but I finally got a close-up pic after having to make some adjustments.
The area where the pins sit go through two layers of fiberglass with about an inch of open space. This was the only place where the pins could go on the radiator support. When the hood is pinned down you can see a low spot around the scuff plate; so what I did was picked up a can of "great stuff" expanding foam to fill in the area. I picked up the can meant for window framing and doors because when it expands enough to fill in the areas it stops expanding whereas the other keeps expanding till the chemical reaction is complete....not good for between layers of fiberglass. This worked out awesome and now when the hood is pinned down there are no more low spots.
Bad quality but this is after I filled with the foam:
Close-up of the pins/scuff plates:
