Quote:
Originally Posted by Jersey Mike
C) There were 6 or so threads on each wire coming off the cutout. Two of them on one wire twisted off--since they're so delicate--while I was twisting them onto the holes in the switch. So, only 2 threads went to each prong for the Green wire. Could there have not been sufficient threads on those two prongs that caused it to not work?
|
This may not be the reason for it not to work, but it's
far from the ideal setup.
Do you have extra wire? If so, cut a few inches off of the green and red wire lengths and use that to jump from corner to corner on the switch. then run the green and red wire left from the cutout to the corners of the switch as directed above.
Understand?
- Justin