Thread: Saab issue
View Single Post
Old 10-11-2009, 09:31 PM   #4
qwikz28
13 Second Club / Moderator
 
qwikz28's Avatar
 
Join Date: Jan 2005
Location: Franklin Lakes, NJ
Posts: 8,694
iTrader: (6)
Social Networks:

Quote:
Originally Posted by sweetbmxrider View Post
doesn't look like it but i know vw's have mounts that need to be in a certain position.

Background
The balancer shafts are most effective within the normal working range of the engine, from 1800 rpm and above. From idling speed up to 1800 rpm , the balancer shafts are unable to counteract engine vibration.
To effectively dampen engine vibrations at lower engine speeds, the rear and right-hand front engine mountings are hydraulic. They are most effective between idling speed and approx. 1800 rpm.
The advantages of hydraulic engine mountings:

* improved damping of horizontal engine movements during acceleration
* improved damping of vertical engine movements on bumpy roads
* improved damping of engine vibration at idling speed
* reduction of structure-borne noise between engine and body.

Description
The hydraulic mounting consists of two chambers filled with a special damping fluid. There is a diaphragm and a passage between the two chambers where the length and cross-sectional area of the passage determines the damping characteristics of the mounting. The diaphragm absorbs the forces generated by the normal small movements of the engine.
The affect of the diaphragm is not sufficient to dampen more pronounced engine movement. Fluid is forced from the upper chamber to the lower chamber, equalizing the pressure. This gives the hydraulic mounting a progressive damping action, resulting in increased resistance with increased load.

hope that helps
I doubt the Saab has any of that fancy stuff. Still interesting though


Quote:
Originally Posted by TaKid455 View Post
If the motor is misaligned with the trans, then you will have some issues. you would see a gap between the trans and motor if this were the situation. I am not aware of this engine having a balance shaft. that would cause a vibration if it was out of sync. this would not be touched if the trans was replaced though. Only if teh timing belt was changed.

the trans and engine can be shifted within the mounts, but about 1/2" max movement which would not affect much. I would ask for clarification on the diagnosis.
there aren't any vibrations, and the trans and timing belt were never serviced. And for what its worth, the car was in only a minor rear end collision that only pushed in the bumper, kinked the quarter panel, and dented the trunk lid; very minor. I guess clarification is needed.

Thanks for the help guys
__________________
Quote:
Originally Posted by LS1ow View Post
Except Jersey mike, great kid, but the way he looks at me makes me feel like im in danger
qwikz28 is offline   Reply With Quote