As many have seen, my engine bay leaves much to the imagination..
I am wanting to relocate the battery into the trunk as my next project.
Plan is to pick up right from the starter and run down the drive shaft tunnel. My question is, what should I do with the wires that I have now hooked to the hot/ground distribution blocks.
I was thinking either running a heavier gauge wire up from the starter to them or relocating them. I think the best bet is to feed them with a larger wire.
And then I was thinking of making the nitrous rats nest all go bye bye and have a nice fused distribution block in the rear of the car off the battery to power the odds and ends I have.
Any thoughts, advice, or what to avoid is much appreciated. Goal is to do it right and clean up the rigged stuff.