|
Help with planning out an engine
I'm planning on taking my 350 block and boring it .060 over and i want to get somewhere in the 500-550hp range and run on pump gas. I have a good bit of money saved up for it and I want to start collecting parts to put it all together. Can someone help me decide on where i should start looking to get more information on what I'm going to have to do? Or tell me what I'm going to have to look at to reach my power gains? IE head flows, compression, domed vs flat top pistons etc...
I'm going to have help from my buddy and his dad who have built several motors for their race cars (dirt track) but I'm just trying to find a broader range of information.
Anything will help, thanks
__________________
1983 camaro- Scrap
1988 camaro- Also scrap
'05 Silverado- You guessed it, scrap
1988 TRX 250R- Ported w/ high compression on 110 octane- Out 60' your LT1
Jersey Shore Street Car Takeover (JSSCT) Founder
Quote:
Originally Posted by LS1ow
and once i get PHB, what do i ajust it too?
|
Quote:
Originally Posted by Jersey Mike
Seven.
|
|