Quote:
Originally Posted by NJ Torque
sounds good...
what kind of power?
|
not sure yet the last time I had it dyno the tranny took a dump ....
The only numbers I was able to get out of it was 427 hp at only 4100 rpm with about 585 pound of torque.... before the vig torque converter let go taking the tranny out. so i am figuring somewhere around 495 to about 510 to the wheels (this is with a very conservative tune is on the rich side and timing is only set at aout 24 total deg i have 9:1 comp so this is not allot of timing) I know if i lean it out turn up the timing i can get about 600 before i am fuel limited (I am running 50 pound injectors single walbro 255 pump with Racetronics, wiring kit)
The short block was built to take a beating ( forged Eagle 3.750 stroker crank, Eagle H-Beam 5.7 rods, 9:1 JE SRP Pistons, Clevite bearings, Oliver 4 bolt splayed caps etc.)