Hey everyone,
I ordered a set of headers for my T/A and can't wait for them to come in.. of course they are backordered, but while I wait I am trying to figure out if there are any tricks for installing them.
Some people tell me they are the biggest pain in the a** to install, others say they really aren't that bad. Either way, they are ordered and are going on the car when they come in ha.
A few people have told me it is easier to put them on if I unbolt the engine mounts, others have told me not, so I am curious about this. I have heard from almost everyone that I should soak the old manifold bolts with PB Blaster for at least 3 days before I attempt to take them off and I know I have to jack up the vehicle quite a bit in order to install them but are there any other tricks that anyone can point out? I have the pontiac 400 6.6 litre.
Also when they do come in, would anyone be interested in coming over to help install them? Im sure it will be loads of fun
