NJFBOA - Home of New Jersey's Camaros and Firebirds - View Single Post

creeper · 02-12-2010, 08:34 AM

if they're y2k's you might have to do a little hammering. they're not very wide but the offset(63mm) causes them to sit "in" a little further than most other wheels. mine would rub a tiny bit when making hard turns, and my rear is probably closer to centered than stock.

lots of people run 1/2" spacers in the front and 1" in the rear so they don't tuck as much, but i didn't think they looked bad just bolting them up.

02-12-2010, 08:34 AM	#4
creeper Join Date: May 2008 Posts: 817 iTrader: (3)	if they're y2k's you might have to do a little hammering. they're not very wide but the offset(63mm) causes them to sit "in" a little further than most other wheels. mine would rub a tiny bit when making hard turns, and my rear is probably closer to centered than stock. lots of people run 1/2" spacers in the front and 1" in the rear so they don't tuck as much, but i didn't think they looked bad just bolting them up. __________________ \|2000 Trans Am\|T56 swap\|Bolt Ons\| Suspension\| Last edited by creeper; 02-12-2010 at 08:49 AM.