[transmaro93]

hey guys i might put the car up on ramps today and try to set the pinion angle the best i can so i can at least drive it without having to worry about f-ing up my rear...i figured on going with a -2 degree angle. is that a good angle to have? but my question is how do i measure this correctly. and also im assuming that negative angle would be the pinion pointing down a bit in relation to the driveshaft... am i correct on that? thanks in advance for any help

ps car is lowered about 1.2-1.5 inches in the rear, t56, strange 12bolt, umi adjustable trans crossmember mounted tq arm.... incase that helps... car is a street strip car that will probably see more street time but will be raced hard when its ready to hit the track... thanks again