View Single Post
Old 03-31-2010, 06:16 PM   #7
Mark42
 
Mark42's Avatar
 
Join Date: Oct 2009
Posts: 443
iTrader: (0)
Quote:
Originally Posted by thunder View Post
oh really? what was the point of that two piece ****? like i just cannot figure it out
Not really sure. Read where it had to do with the angle that the trans sat at in the 6, to the center bearing mount dampens some odd vibration in the 6. But the fact is GM saved money by doing 1 piece in all models. So whatever issue it was meant to address, it apparently wasn't bad enough to continue to spend money on the two piece setup.
__________________

1998 Firebird Coupe
Mods: 3.73 Gears, Eaton TrueTrac, PCM Tune, LS1 Aluminum Drive Shaft, Cold Air Intake, 180 Thermostat, Magnaflow Cat-Back Exhaust, Moog LCA busings.

My Firebird Projects
: Click Here


Last edited by Mark42; 03-31-2010 at 06:19 PM.
Mark42 is offline   Reply With Quote