[crazyblazer87]

REMOVAL
1.Disconnect negative cable from battery.
2.If vehicle has a tilt column, remove tilt lever by turning it counterclockwise.
3.Remove upper and lower covers from steering column Shroud Removal/Installation - Typical
4.Remove ignition switch mounting screws. Use tamper proof torx bit Snap-on TTXR20A2 or equivalent to remove the screws Ignition Switch Screw Removal or Ignition Switch Screw Removal
5.Gently pull switch away from column. Release connector locks on 7-terminal wiring connector, then remove connector from ignition switch.
6.Release connector lock on 4-terminal connector, then remove connector from ignition switch Key-In-Switch and Halo Lamp Connector
7.To remove key cylinder from ignition switch:
a.Insert key in ignition switch. Turn key to LOCK position. Using a TTXR20A2 or equivalent torx bit, remove key cylinder retaining screw and bracket Key Cylinder Retaining Screw or Key Cylinder Retaining Screw
b.Rotate key clockwise to the OFF position. Key cylinder will unseat from ignition switch Unseated Key Cylinder When key cylinder is unseated, it will be approximately 1/8 inch away from ignition switch halo light ring. Do not attempt to remove key cylinder at this time.
c.With key cylinder in unseated position, rotate key counterclockwise to the lock position and remove key.
d.With key cylinder in unseated position, rotate key counterclockwise to the lock position and remove key.
e.Remove key cylinder from ignition switch Key Cylinder Removal